How to use U-Boot on Freescale MX6UL 14x14 EVK¶
Build U-Boot for MX6UL 14x14 EVK:
$ make mrproper $ make mx6ul_14x14_evk_defconfig $ make
This will generate the SPL image called SPL and the u-boot.img.
1. Booting via SDCard¶
Flash the SPL image into the micro SD card:
sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1 conv=notrunc; sync
Flash the u-boot.img image into the micro SD card:
sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69 conv=notrunc; sync
SW601: 0 0 1 0 Sw602: 1 0
where 0 means bottom position and 1 means top position (from the switch label numbers reference).
Connect the USB cable between the EVK and the PC for the console. The USB console connector is the one close the push buttons
Insert the micro SD card in the board, power it up and U-Boot messages should come up.
2. Booting via Serial Download Protocol (SDP)¶
The mx6ulevk board can boot from USB OTG port using the SDP, target will enter in SDP mode in case an SD Card is not connect or boot switches are set as below:
Sw602: 0 1 SW601: x x x x
The following tools can be used to boot via SDP, for both tools you must connect an USB cable in USB OTG port.
Method 1: Universal Update Utility (uuu)
The UUU binary can be downloaded in release tab from link below: https://github.com/NXPmicro/mfgtools
The following script should be created to boot SPL + u-boot-dtb.img binaries:
$ cat uuu_script uuu_version 1.1.4 SDP: boot -f SPL SDPU: write -f u-boot-dtb.img -addr 0x877fffc0 SDPU: jump -addr 0x877fffc0 SDPU: done
Please note that the address above is calculated based on TEXT_BASE address:
0x877fffc0 = 0x87800000 (TEXT_BASE) - 0x40 (U-Boot proper Header size)
Power on the target and run the following command from U-Boot root directory:
$ sudo ./uuu uuu_script
Method 2: imx usb loader tool (imx_usb):
The imx_usb_loader tool can be downloaded in link below: https://github.com/boundarydevices/imx_usb_loader
Build the source code and run the following commands from U-Boot root directory:
$ sudo ./imx_usb SPL $ sudo ./imx_usb u-boot-dtb.img