Device Tree Overlays

Overlay Syntax

Device-tree overlays require a slightly different syntax compared to traditional device-trees. Please refer to dt-object-internal.txt in the device-tree compiler sources for information regarding the internal format of overlays: https://git.kernel.org/pub/scm/utils/dtc/dtc.git/tree/Documentation/dt-object-internal.txt

Building Overlays

In a nutshell overlays provides a means to manipulate a symbol a previous device-tree or device-tree overlay has defined. It requires both the base device-tree and all the overlays to be compiled with the -@ command line switch of the device-tree compiler so that symbol information is included.

Note

Support for -@ option can only be found in dtc version 1.4.4 or newer. Only version 4.14 or higher of the Linux kernel includes a built in version of dtc that meets this requirement.

Building a binary device-tree overlay follows the same process as building a traditional binary device-tree. For example:

base.dts

/dts-v1/;
/ {
        foo: foonode {
                foo-property;
        };
};
$ dtc -@ -I dts -O dtb -o base.dtb base.dts

overlay.dtso

/dts-v1/;
/plugin/;
/ {
        fragment@1 {
                target = <&foo>;
                __overlay__ {
                        overlay-1-property;
                        bar: barnode {
                                bar-property;
                        };
                };
        };
};
$ dtc -@ -I dts -O dtb -o overlay.dtbo overlay.dtso

Ways to Utilize Overlays in U-Boot

There are two ways to apply overlays in U-Boot.

  • Include and define overlays within a FIT image and have overlays automatically applied.

  • Manually load and apply overlays

The remainder of this document will discuss using overlays via the manual approach. For information on using overlays as part of a FIT image please see: doc/uImage.FIT/overlay-fdt-boot.txt

Manually Loading and Applying Overlays

  1. Figure out where to place both the base device tree blob and the overlay. Make sure you have enough space to grow the base tree without overlapping anything.

=> setenv fdtaddr 0x87f00000
=> setenv fdtovaddr 0x87fc0000
  1. Load the base binary device-tree and the binary device-tree overlay.

=> load ${devtype} ${bootpart} ${fdtaddr} ${bootdir}/base.dtb
=> load ${devtype} ${bootpart} ${fdtovaddr} ${bootdir}/overlay.dtbo
  1. Set the base binary device-tree as the working fdt tree.

=> fdt addr $fdtaddr
  1. Grow it enough so it can encompass all applied overlays

=> fdt resize 8192
  1. You are now ready to apply the overlay.

=> fdt apply $fdtovaddr
  1. Boot system like you would do with a traditional dtb.

For bootm:

=> bootm ${kerneladdr} - ${fdtaddr}

For bootz:

=> bootz ${kerneladdr} - ${fdtaddr}

Please note that in case of an error, both the base and overlays are going to be invalidated, so keep copies to avoid reloading.