Kontron pitx-imx8m¶
The Kontron pitx-imx8m is an embedded board with an i.MX8MQ in the pITX form factor.
The board has two Ethernet ports, USB, HDMI/LVDS, m.2 slot, SD card, CAN, RS232 and much more.
Quick Start¶
Get and build the ARM Trusted firmware binary
Get DDR and HDMI firmware
Build U-Boot
Install on SD card
Boot
Get and build the ARM Trusted firmware binary¶
Note: builddir is U-Boot build directory (source directory for in-tree builds)
$ git clone https://github.com/ARM-software/arm-trusted-firmware.git
$ git checkout v2.5
$ make PLAT=imx8mq ARCH=aarch64 CROSS_COMPILE=aarch64-linux-gnu- bl31
$ cp build/imx8mq/release/bl31.bin $(builddir)
Get DDR and HDMI firmware¶
Note: builddir is U-Boot build directory (source directory for in-tree builds)
$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.11.bin
$ chmod +x firmware-imx-8.11.bin
$ ./firmware-imx-8.11
$ cp firmware-imx-8.11/firmware/ddr/synopsys/lpddr4*.bin $(builddir)
$ cp firmware-imx-8.11/firmware/hdmi/cadence/signed_hdmi_imx8m.bin $(builddir)
Build U-Boot¶
$ make kontron_pitx_imx8m_defconfig
$ make CROSS_COMPILE=aarch64-linux-gnu-
Install on SD card¶
Burn the flash.bin to SD card at an offset of 33 KiB:
$ sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=33
Boot¶
Set the boot source selection to SD card boot and power on the board.